How to Properly Soak Wet Floral Foam

How to Properly Soak Wet Floral Foam

Proper soaking prepares wet floral foam for fresh flower arrangements. For best results, follow the instructions for your specific product.

1. Prepare a Clean Container

Choose a clean container large enough for the foam to float freely. Add enough clean water for the block to become fully submerged as it absorbs water. If using flower food, follow the dosage instructions on its packaging.

2. Place the Foam on the Water

Set the foam gently on the water’s surface and allow it to absorb naturally. Do not push it underwater or press it down, as this may trap air inside and leave dry areas.

3. Allow the Foam to Become Fully Saturated

Wait until the foam sinks and bubbles stop rising. VerdanBloom wet floral foam can absorb water throughout the block in as little as 50 seconds and offers strong water retention for fresh flower arrangements. Actual soaking time may vary depending on the foam size and water conditions.

4. Lift and Position the Foam

Once saturated, lift the foam carefully and let excess water drain briefly. Place it in a suitable container, tray, or floral base. Secure it if the arrangement requires additional stability.

5. Insert Flower Stems Carefully

Trim stems before inserting them. Push each stem into the foam with a steady motion. Avoid removing and reinserting stems into the same hole, as this can loosen the foam and affect support.

Common Soaking Mistakes to Avoid

• Do not force the foam underwater.
• Use a container large enough for the foam to float freely.
• Avoid removing the foam before it has fully sunk.
• Use fresh foam for each arrangement, since existing stem holes can affect support and water distribution.

Proper soaking helps prepare the foam for arranging. The container, flower stems, and design also affect the final result, so follow the guidance supplied with your specific product.